Master Cylinder: Installation
WARNING: This page is about a different car, the 2003 Pontiac Montana, 2003 Oldsmobile Silhouette, and 2003 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.
- Bench bleed the master cylinder. See MASTER CYLINDER BLEEDING under BLEEDING BRAKE SYSTEM. Install the master cylinder to the brake booster. Install the master cylinder mounting nuts. Tighten the nuts to specifications. See TORQUE SPECIFICATIONS .
- Remove the plugs from the brake pipes. Connect the brake pipes to the master cylinder. Tighten the fittings to specifications. See TORQUE SPECIFICATIONS . Connect the electrical connector to the brake fluid level sensor. Bleed the hydraulic brake system. See BLEEDING BRAKE SYSTEM .