LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 326 (Disc Brakes & Drum Brakes) >> Removal & Installation >> Drum Brake Backing Plate >> Installation

Drum Brake Backing Plate: Installation

WARNING: This page is about a different car, the 2003 Pontiac Montana, 2003 Oldsmobile Silhouette, and 2003 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the backing plate. Install the wheel bearing/hub. See appropriate REAR SUSPENSION article in SUSPENSION. Install the wheel cylinder. Install the universal spring. See WHEEL CYLINDER  under REMOVAL & INSTALLATION.
  2. Install the park brake cable to the backing plate. See REAR PARK BRAKE CABLE  under REMOVAL & INSTALLATION.
  3. Install the brake shoes. See BRAKE SHOES  under REMOVAL & INSTALLATION.
  4. Adjust the drum brakes. See DRUM BRAKE ADJUSTMENT  under ADJUSTMENTS & INSPECTIONS.
  5. Install the brake drum. See BRAKE DRUM  under REMOVAL & INSTALLATION.
  6. Bleed the brake hydraulic system. See MANUAL BLEEDING  under BLEEDING BRAKE SYSTEM.
  7. Adjust the park brake. See DRUM PARK BRAKE ADJUSTMENT  or DISC PARKING BRAKE ADJUSTMENT  under ADJUSTMENTS & INSPECTIONS. Install the Tire and Wheel. See TORQUE SPECIFICATIONS  . Lower Vehicle.
scientia non olet · About LEMON Manuals