LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 32 (Rear Suspension System) >> Removal & Installation >> Stabilizer Shaft Insulator >> Removal

Stabilizer Shaft Insulator: Removal

WARNING: This page is about a different car, the 2002 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle.
  2. Remove the stabilizer shaft link assembly bolt and nut. See Figure.
  3. Remove the retainer and insulators from the control arm.
  4. Remove the stabilizer shaft clamp bolt. See Fig 1.
  5. Bend the open end of the clamp upward.
  6. Remove the stabilizer shaft and insulators. See Fig 2.
Fig 1: Removing Stabilizer Shaft Clamp Bolt
G00372192Courtesy of GENERAL MOTORS CORP.
Fig 2: Removing Stabilizer Shaft & Insulators
G00372193Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals