LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 32 (Rear Suspension System) >> Removal & Installation >> Hub & Bearing Assembly >> Removal

Hub & Bearing Assembly: Removal

WARNING: This page is about a different car, the 2002 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise the vehicle.
  2. Remove the brake rotor. See BRAKE ROTORS .
  3. Remove the ABS sensor harness connector.
  4. Remove the 4 bolts from the control arm. See Fig 1.
  5. Remove the hub and bearing from the control arm.
  6. Remove the brake shield from the control arm.
  7. Clean the control arm face and the bore before installing the hub and the bearing.
Fig 1: Removing & Installing Hub & Bearing Assembly
G95C13013Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals