LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 304 (Air Bag Restraint Systems) >> Removal & Installation >> Air Bag Modules >> Removal & Installation (Passenger-side)

Removal & Installation (Passenger-side)

WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Before proceeding, see AIR BAG SAFETY PRECAUTIONS . Disable air bag system. See DISABLING & ACTIVATING AIR BAG SYSTEM .
  2. Remove instrument panel trim pad. See INSTRUMENT PANEL TRIM PAD . Remove screws from radio. Remove radio from instrument panel and disconnect radio antenna, electrical connector and ground cable from radio. Remove passenger air outlet duct screw. Remove passenger air outlet duct.
  3. Remove bolts securing passenger-side air bag module to cross car beam. See Fig 1. Unsnap air bag retainers. Remove passenger-side air bag module.
  4. To install, reverse removal procedure. Tighten passenger-side air bag module bolts and air duct screw to specification. See TORQUE SPECIFICATIONS . Activate air bag system.
Fig 1: Identifying Passenger-side Air Bag Module
G99C26239Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals