LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 301 (Supplemental Inflatable Restraint System) >> Removal & Installation >> Passenger-Side Air Bag Module Disable Switch Indicator >> Removal & Installation

Removal & Installation

WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

Before proceeding, see AIR BAG SAFETY PRECAUTIONS . Ensure ignition is off and key is removed. Open center console compartment door. Lift up on accessory trim plate to gain access to passenger-side disable switch indicator electrical connector. Disconnect passenger-side air bag module disable switch indicator from wiring harness connector. Use Terminal Extractor (J-35616-A) to remove LED terminals from LED connector. To install, reverse removal procedure.

scientia non olet · About LEMON Manuals