LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 299 (Supplemental Inflatable Restraint System) >> Disabling & Activating Air Bag System >> Disabling System >> Zone 9

Zone 9

WARNING: This page is about a different car, the 2003 Pontiac Montana, 2003 Oldsmobile Silhouette, and 2003 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn steering wheel to place vehicle wheels in straight-ahead position. Turn ignition off and remove key. Remove SDM fuse (15-amp) from instrument panel fuse block, located on right side of instrument panel.
  2. If disabling passenger side impact air bag module and seat belt pretensioner, go to step  6. If disabling entire SIR system, complete all remaining steps.
  3. Remove driver-side knee bolster. Remove Connector Position Assurance (CPA) clip from driver-side air bag module connector. See Figure. Disconnect driver-side air bag module connector.
  4. Remove passenger-side knee bolster. Remove CPA clip from passenger-side air bag module connector. See Figure. Disconnect connector.
  5. Remove CPA clips from driver side impact air bag and seat belt pretensioner connectors. See Figure. Disconnect driver seat belt pretensioner and side impact air bag connectors.
  6. Remove CPA clips from passenger side impact air bag module and seat belt pretensioner connectors. See Figure. Disconnect passenger side impact air bag module and seat belt pretensioner connectors.
scientia non olet · About LEMON Manuals