Zone 6
WARNING: This page is about a different car, the 2003 Pontiac Montana, 2003 Oldsmobile Silhouette, and 2003 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.
- Ensure ignition is off and key is removed. Connect Side Impact Sensor (SIS) harness connector to SIS. Install Connector Position Assurance (CPA) clip. Install SIS in driver-side B-pillar. See SIDE IMPACT SENSOR (SIS) under REMOVAL & INSTALLATION. Install lower B-pillar trim panel.
- Install SDM (15-amp) fuse located on right side of instrument panel. Install fuse block cover.
- Staying well away from air bag modules, turn ignition on. Check system for proper operation. See SYSTEM OPERATION CHECK .