Removal & Installation

WARNING: This page is about a different car, the 2003 Pontiac Grand Prix, 2003 Chevrolet Monte Carlo, 2003 Chevrolet Impala, 2003 Buick Regal, and 2003 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.

Remove fuel sender assembly from fuel tank. See FUEL SENDER ASSEMBLY . Remove the fuel level sensor electrical connector retaining clip. Disconnect the fuel level sensor electrical connector from under the fuel sender cover.
Remove the fuel level sensor retaining clip. Squeeze the locking tangs and remove the fuel level sensor. See Fig 1. To install, reverse removal procedure.

Fig 1: Identifying Fuel Sender Assembly Components

Courtesy of GENERAL MOTORS CORP.