LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 297 (Engine Controls - Removal & Installation - V6 & V8) >> Emission Systems & Sub-Systems >> Secondary Air Injection Vacuum Control Solenoid >> Removal & Installation (3.8L)

Removal & Installation (3.8L)

WARNING: This page is about a different car, the 2003 Pontiac Grand Prix, 2003 Chevrolet Monte Carlo, 2003 Chevrolet Impala, 2003 Buick Regal, and 2003 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.

Turn OFF the ignition. Disconnect the vacuum hoses from the Secondary Air Injection (AIR) vacuum control solenoid. See Fig 1. Disconnect the electrical connector from the solenoid. Remove the solenoid fastener. Remove the solenoid from the vehicle. To install, reverse removal procedure.

Fig 1: Locating Secondary Air Injection Vacuum Control Solenoid (3.8L)
G00158352Courtesy of GENERAL MOTORS CORP.