LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 277 (Engine Mechanical - 3.5L (On-Vehicle)) >> Repair Instructions >> Drive Belt Tensioner Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the drive belt tensioner.
    CAUTION: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the drive belt tensioner bolt to the cylinder head (1).

    Tighten 

    Tighten the drive belt tensioner bolt to 50 N.m (37 lb ft).

  3. Install the drive belt. Refer to DRIVE BELT REPLACEMENT .
    Fig 1: Installing Drive Belt Tensioner
    G01816621Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals