LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 277 (Engine Mechanical - 3.5L (On-Vehicle)) >> Repair Instructions >> Drive Belt Idler Pulley Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the idler pulley.
    CAUTION: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the idler pulley bolt.

    Tighten 

    Tighten the idler pulley bolt to 50 N.m (37 lb ft).

  3. Install the drive belt. Refer to Drive Belt Replacement .
    Fig 1: Installing Drive Belt Idler Pulley
    G01816623Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals