LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 257 (Engine Controls - Removal & Installation) >> Sensors >> Heated Oxygen Sensor >> Removal (HO2S 1)

Removal (HO2S 1)

WARNING: This page is about a different car, the 2003 Pontiac Bonneville, 2003 Buick Park Avenue, and 2003 Buick LeSabre. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn OFF the ignition. HO2S 1 is located in exhaust manifold. See Figure. Remove fuel injector sight shield (upper engine cover) from engine. Remove the HO2S 1 retaining clip from the bracket.
  2. Disconnect the HO2S electrical connector tab from the HO2S 1 retaining clip. Remove the HO2S electrical connector retainer. Raise and support the vehicle. harness connector. Using Heated Oxygen Sensor Wrench (J-39194), remove the HO2S from the exhaust manifold.
scientia non olet · About LEMON Manuals