Test Description

The numbers below refer to the step numbers in the diagnostic procedures.

1. 1
   
   This step ensures that the technician has performed a Diagnostic System Check on the Manual Transmission System.
2. 2
   
   This test confirms if the scan tool is receiving a clutch switch position signal.
3. 3
   
   This step inspects the clutch pedal connector and adjustment.
4. 4
   
   This step tests for a short to ground.
5. 5
   
   This step tests for voltage to the fuse.
6. 6
   
   This step tests for voltage to the clutch pedal position switch.
7. 7
   
   This step tests the clutch pedal position switch.
8. 8
   
   This step tests the clutch pedal position switch signal circuit.
9. 9
   
   This step tests the ignition 1 voltage circuit for a short to ground.
10. 10
    
    This step tests the clutch pedal position switch signal circuit for a ground.
11. 17
    
    This step ensures that the technician has verified the system is operating normally.