LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 250 (Engine Controls - Removal & Installation) >> Solenoids >> EVAP Purge Solenoid >> Removal & Installation (2.2L)

Removal & Installation (2.2L)

WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn OFF the ignition. Disconnect both purge link quick-connects from EVAP purge solenoid. See Fig 1 . Disconnect EVAP purge solenoid harness connector. Slide EVAP purge solenoid from retaining bracket.
  2. Slide EVAP purge solenoid into retaining bracket. Connect purge line quick-connects to EVAP purge solenoid. Push in connector until a click is heard, then pull back to confirm positive engagement. Connect EVAP purge solenoid harness connector.
Fig 1: Removing/Installing EVAP Purge Solenoid (2.2L)
G00165016Courtesy of GENERAL MOTORS CORP.
Fig 2: Removing/Installing EVAP Purge Solenoid (3.0L)
G00217106Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals