LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 250 (Engine Controls - Removal & Installation) >> Sensors & Switches >> Manifold Absolute Pressure Sensor (2.2L) >> Installation

Manifold Absolute Pressure Sensor (2.2L): Installation

WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install MAP sensor with port seal into intake manifold. Connect MAP sensor electrical connector. Push in connector until a click is heard and pull back to confirm a positive engagement. Install outlet resonator/duct assembly into position. Connect PCV fresh air vent hose assembly.
  2. Tighten clamp at throttle body assembly. Position outlet resonator/duct assembly up with support bracket and install push pin. Tighten clamp at air cleaner assembly. Connect IAT sensor connector.
scientia non olet · About LEMON Manuals