Throttle Position Sensor: Removal
WARNING: This page is about a different car, the 2003 Pontiac Montana, 2003 Oldsmobile Silhouette, and 2003 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.
- Turn OFF the ignition. Remove the air cleaner intake duct. See AIR CLEANER INTAKE DUCT under AIR INDUCTION SYSTEMS. Disconnect the EVAP purge line. Release fuel system pressure. See FUEL SYSTEM PRESSURE RELEASE .
- Disconnect the fuel lines. See FUEL LINE DISCONNECT FITTINGS under FUEL SYSTEMS. Disconnect the Throttle Position (TP) sensor electrical connector. See Figure. Remove the 2 TP sensor screws. Remove the TP sensor and "O" ring.