LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 245 (Engine Controls - Removal & Installation & Overhaul) >> Sensors >> Camshaft Position Sensor >> Removal

Camshaft Position Sensor: Removal

WARNING: This page is about a different car, the 2003 Pontiac Montana, 2003 Oldsmobile Silhouette, and 2003 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.
  1. The Camshaft Position (CMP) sensor is located at top front of cylinder block. See Figure. Turn ignition off. Remove the accessory drive belt from the power steering pump.
  2. Remove the power steering pump. See appropriate POWER RACK & PINION article in STEERING. Disconnect the CMP sensor electrical connector. Remove the attaching bolt. Remove the CMP sensor. Inspect the sensor "O" ring for wear, cracks, or leakage if the sensor is not being replaced.
scientia non olet · About LEMON Manuals