Camshaft Position Sensor: Installation
WARNING: This page is about a different car, the 2003 Pontiac Montana, 2003 Oldsmobile Silhouette, and 2003 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Inspect the CMP sensor "O" ring for wear or damage. If a problem is found, replace the "O"ring.
Lubricate the "O" ring with clean engine oil. Install the CMP sensor. Tighten the CMP sensor retaining bolt to specification. See TORQUE SPECIFICATIONS . Connect the CMP sensor electrical connector. Install the power steering pump to the vehicle.