LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 245 (Engine Controls - Removal & Installation & Overhaul) >> Miscellaneous >> Accelerator Controls Cable Bracket >> Installation

Accelerator Controls Cable Bracket: Installation

WARNING: This page is about a different car, the 2003 Pontiac Montana, 2003 Oldsmobile Silhouette, and 2003 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the accelerator cable bracket on the throttle body. Install the accelerator cable bracket nut and bolts. Tighten the bolts/nut in sequence to specification. See Fig 3. See TORQUE SPECIFICATIONS .
  2. Install the wire harness into the retainer. Install the air cleaner intake duct. See AIR CLEANER INTAKE DUCT  under AIR INDUCTION SYSTEMS.
  3. Connect the accelerator cable to the throttle body lever. Connect the accelerator cable to the accelerator cable bracket. Connect the cruise control cable from the throttle lever and accelerator bracket, if applicable.
Fig 1: Identifying Accelerator Controls Cable
G00217075Courtesy of GENERAL MOTORS CORP.
Fig 2: Identifying Cruise Control Cable
G00209123Courtesy of GENERAL MOTORS CORP.
Fig 3: Accelerator Cable Bracket Bolt/Nut Tightening Sequence
G00114772Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals