LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 245 (Engine Controls - Removal & Installation & Overhaul) >> Emission Systems & Sub-Systems >> Secondary Air Injection Shut-Off Valve >> Removal (Rear Valve)

Removal (Rear Valve)

WARNING: This page is about a different car, the 2003 Pontiac Montana, 2003 Oldsmobile Silhouette, and 2003 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.
  1. Rear shut-off valve is located on rear cylinder head, near ignition coils. See Figure. Turn OFF the ignition. Remove the air cleaner intake duct. See AIR CLEANER INTAKE DUCT  under AIR INDUCTION SYSTEMS.
  2. Set the park brake. Shift the transaxle into Neutral. Remove the engine mount strut bolts. See Figure. Swing the engine mount struts aside.
  3. Install the Engine Tilter Strap (J-41131) to the engine. See Figure. Pull on the engine in order to rotate the engine forward. Tighten the engine tilter strap.
  4. Remove the ignition control module and coils. See IGNITION CONTROL MODULE  under IGNITION SYSTEMS.
  5. Disconnect the AIR crossover pipe from the shut-off valve. See Figure.
  6. Disconnect the vacuum line from the shut-off valve. Figure. Remove the AIR shut-off valve nut. Remove the shut-off valve bolts from the manifold pipe. Remove the shut-off valve.
scientia non olet · About LEMON Manuals