LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 245 (Engine Controls - Removal & Installation & Overhaul) >> Air Induction Systems >> Throttle Body >> Removal

Throttle Body: Removal

WARNING: This page is about a different car, the 2003 Pontiac Montana, 2003 Oldsmobile Silhouette, and 2003 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.
  1. Partially drain the coolant. Remove the air cleaner intake duct. See AIR CLEANER INTAKE DUCT .
  2. Disconnect the Idle Air Control (IAC) valve electrical connector. See Figure. Disconnect the Throttle Position (TP) sensor electrical connector. Remove the accelerator controls cable bracket. See ACCELERATOR CONTROLS CABLE BRACKET  under MISCELLANEOUS.
  3. Disconnect the throttle body coolant by-pass hoses. Disconnect the heater pipe nut at the throttle body. Remove the nuts and bolts holding the throttle body to the intake manifold. Remove the throttle body assembly. Remove the old gasket.
scientia non olet · About LEMON Manuals