Removal & Installation
WARNING: This page is about a different car, the 2003 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.
Remove the Camshaft Position (CMP) sensor electrical connector. See Fig 1 . Remove the CMP sensor retaining bolt. Remove the CMP sensor. Inspect the CMP sensor "O" ring for wear or damage. If a problem is found, replace the "O"ring. To install, reverse removal procedure. Lubricate the CMP sensor "O" ring with engine oil. Tighten CMP sensor bolt to specification. See TORQUE SPECIFICATIONS .