Cruise Control Cable (4.0L V8): Installation

WARNING: This page is about a different car, the 2002 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.

Install the cruise control cable ball stud (1) into the slot in the cruise control module actuator strip (2). See Figure.
Insert the cruise control cable housing into the cruise control module and twist clockwise to secure.
Connect the cruise control cable to the throttle body cam (1). See Fig 1.
Snap the cable clip (3) to the throttle body bracket.
Install the cable into the retainers (2).
Adjust the cruise control cable. See CRUISE CONTROL CABLE under ADJUSTMENTS.

Fig 1: Removing & Installing Cruise Control Cable To Throttle Body (4.0L V8)

Courtesy of GENERAL MOTORS CORP.

Fig 2: Removing & Installing Cruise Control Cable Into Retainers (4.0L V8)

Courtesy of GENERAL MOTORS CORP.