Diagnostic Aids
WARNING: This page is about a different car, the 2003 Pontiac Montana, 2003 Oldsmobile Silhouette, and 2003 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.
Inspect for the following conditions:
- High resistance in an IAC circuit.
- The correct PCV valve, properly installed and proper operation of the PCV valve.
- Proper operation and installation of all air intake components.
- Proper installation and operation of the Mass Airflow (MAF) sensor, if equipped.
- A tampered with or damaged throttle stop screw.
- A tampered with or damaged throttle plate, throttle shaft, throttle linkage, or cruise control linkage, if equipped.
- A skewed high TP sensor.
- Excessive deposits in the IAC passage or on the IAC pintle.
- Excessive deposits in the throttle bore or on the throttle plate.
- Vacuum leaks.
- A high or unstable idle condition could be caused by a non-IAC system problem that can not be overcome by the IAC valve.
If the problem is determined to be intermittent, see INTERMITTENTS in TROUBLE SHOOTING - NO CODES - 3.4L MONTANA, SILHOUETTE & VENTURE article.