LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 232 (Engine Mechanical - 3.1L V6 - VIN (J) (On-Vehicle)) >> Repair Instructions >> Crankshaft Balancer Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
  1. Apply sealant to the keyway of the balancer. Use sealant GM P/N 12345739 (Canadian P/N 10953472) or equivalent.
  2. Install the crankshaft balancer. Use the J 29113.
  3. Remove the J 29113.
  4. Install the J 37096 to the flywheel to prevent flywheel rotation.
    Fig 1: Installing Crank Shaft Balancer
    G01763602Courtesy of GENERAL MOTORS CORP.
  5. Install the crankshaft balancer washer and the bolt.

    Tighten: 

    Tighten the bolt to 103 N.m (76 ft lbs) 

    Fig 2: Crankshaft Balancer Washer And The Bolt
    G01763603Courtesy of GENERAL MOTORS CORP.
  6. Remove the J 37096 from the flywheel.
  7. Raise the frame to the original position.
  8. Install and tighten the frame bolts.
  9. Install the right engine splash shield. Refer to SPLASH SHIELD REPLACEMENT - ENGINE in BODY FRONT END .
  10. Install the right front tire and wheel.
  11. Lower the vehicle.
  12. Install the drive belt. Refer to Drive Belt Replacement .
  13. Perform a CKP system variation learn procedure. Refer to CKP SYSTEM VARIATION LEARN PROCEDURE in ENGINE CONTROLS - REMOVAL & INSTALLATION, OVERHAUL .
scientia non olet · About LEMON Manuals