Test G: Defrosting Insufficient
WARNING: This page is about a different car, the 2002 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
For circuit reference, see CONNECTOR IDENTIFICATION and/or WIRING DIAGRAMS
.
- If diagnostic system check was not performed, go to DIAGNOSTIC SYSTEM CHECK under SELF-DIAGNOSTIC SYSTEM. If diagnostic system check was performed, go to next step.
- Measure engine operating temperature. If engine operating temperature is within specifications, go to next step. If engine operating temperature is not within specifications, go to step 4.
- Place blower control switch at minimum speed. Place temperature control at maximum position. Feel temperature of inlet and outlet hoses at heater core. If inlet hose feels warmer than outlet hose, go to step 5. If inlet hose does not feel warmer than outlet hose, go to step 11.
- Diagnose and repair low engine temperature condition. When repair is complete, go to step 13.
- Check A/C compressor clutch operation. If A/C compressor clutch engages, go to step 7. If A/C compressor clutch does not engage, go to next step.
- Diagnose and repair A/C compressor clutch condition. See TEST F: COMPRESSOR CLUTCH DOES NOT ENGAGE . Repair as necessary. When repairs are complete, go to step 13.
- Perform A/C SYSTEM PERFORMANCE TEST. See A/C SYSTEM PERFORMANCE TEST under PERFORMANCE TESTS. If A/C system is operating within specifications, go to next step. If A/C system is not operating within specifications, go to step 10.
- Ensure correct operation of recirculation door. If recirculation door is operating correctly, go to step 13. If recirculation door is not operating correctly, go to step, 12.
- Diagnose and repair air delivery condition. See TEST A: AIR DELIVERY IMPROPER under SYMPTOM TESTS. When repairs are complete, go to step 13.
- Diagnose and repair A/C performance condition. See A/C SYSTEM PERFORMANCE TEST under PERFORMANCE TESTS. When repairs are complete, go to step 13.
- Diagnose and repair Heating System performance condition. See HEATING PERFORMANCE under PERFORMANCE TESTS. When repairs are complete, go to step 13.
- Make necessary repairs to recirculation door. When repairs are complete, go to next step.
- Operate system to verify repair. If condition is corrected, system is okay. If condition is not corrected, go to step 2.