LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 225 (Automatic Transmission Servicing) >> Removal & Installation >> Vehicle Speed Sensor >> Removal

Vehicle Speed Sensor: Removal

WARNING: This page is about a different car, the 2003 Pontiac Montana, 2003 Oldsmobile Silhouette, and 2003 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle.
  2. Remove the right front tire and wheel assembly.
  3. Remove the right engine splash shield.
  4. Remove the vehicle speed sensor wiring harness connector.
  5. Remove the vehicle speed sensor bolt (9). See Fig 1 .
  6. Remove the vehicle speed sensor (10) from the extension case.
  7. Remove the "O" ring (11) from the vehicle speed sensor (10). See Fig 2 .
    NOTE: Handle the vehicle speed sensor (10) carefully.
  8. Inspect the vehicle speed sensor and "O" ring seal for the following:
    • Damaged connector.
    • Cracked housing.
    • Signs of rotor damage.
    • Cuts or nicks on the "O" ring seal (11).
Fig 1: Removing & Installing Vehicle Speed Sensor
G00087710Courtesy of GENERAL MOTORS CORP.
Fig 2: Removing & Installing Vehicle Speed Sensor "O" Ring
G00087711Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals