Reverse Servo: Removal
WARNING: This page is about a different car, the 2003 Pontiac Montana, 2003 Oldsmobile Silhouette, and 2003 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the throttle body air inlet duct.
- Use a large flat-blade tool in order to depress the reverse servo cover. See Fig 1 .
- Use a small flat-blade tool in order to remove the retaining ring. See Fig 2 .
- Use a small flat-blade tool in order to pull the "O" ring seal out through the slot in the case.
- Use side cutting pliers in order to cut the servo cover "O" ring seal.
- Depress the reverse servo cover, grasp one end of the cut seal and pull the seal out of the servo cover.
- Use a large flat-blade tool in order to depress the reverse servo cover, grasp one end of the cut seal and pull the seal out of the servo cover.
- Remove the reverse servo cover. See Fig 2 .
- Remove the servo assembly.
- Remove the servo spring.