LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 225 (Automatic Transmission Servicing) >> Removal & Installation >> Reverse Servo >> Installation

Reverse Servo: Installation

WARNING: This page is about a different car, the 2003 Pontiac Montana, 2003 Oldsmobile Silhouette, and 2003 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Failure to perform the following step may result in no reverse gear due to the servo pin not aligning with the reverse band.
  1. Raise the driver (left) side of the vehicle until it is higher than the passenger (right) differential side. This ensures that the reverse band is in the proper location.
  2. Install the servo spring. See Figure .
  3. Install the servo assembly.
  4. Install the reverse servo cover with new "O" ring seal. See Figure .
  5. Install the snap ring.
  6. Install the throttle body air inlet duct.
scientia non olet · About LEMON Manuals