LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 225 (Automatic Transmission Servicing) >> Removal & Installation >> Oil Cooler Pipes >> Removal

Oil Cooler Pipes: Removal

WARNING: This page is about a different car, the 2003 Pontiac Montana, 2003 Oldsmobile Silhouette, and 2003 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the Transaxle Oil Cooler (TOC) outlet hose from top side of the radiator. See OIL COOLER PIPES QUICK CONNECT FITTING  .
  2. Raise and support the vehicle.
  3. Remove the TOC hose retainer bolt. See Fig 1 .
  4. Position a drain pan below the oil cooler hoses.
  5. Remove the TOC inlet hose from the transaxle. See Fig 2 .
  6. Remove the TOC outlet hose from the transaxle. See Fig 3 .
  7. Remove the TOC hoses from the radiator. See Fig 4 .
  8. Disconnect the TOC hoses from the radiator support retainer.
  9. Remove the TOC hoses.
Fig 1: Removing & Installing Oil Cooler Retainer Bolt
G00087759Courtesy of GENERAL MOTORS CORP.
Fig 2: Removing & Installing Inlet Oil Cooler Hose
G00087767Courtesy of GENERAL MOTORS CORP.
Fig 3: Removing & installing Outlet Oil Cooler Hose
G00087768Courtesy of GENERAL MOTORS CORP.
Fig 4: Removing & Installing Oil Cooler Pipes At Radiator
G00087758Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals