LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 225 (Automatic Transmission Servicing) >> Removal & Installation >> Oil Cooler Pipes >> Installation

Oil Cooler Pipes: Installation

WARNING: This page is about a different car, the 2003 Pontiac Montana, 2003 Oldsmobile Silhouette, and 2003 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Allow sufficient clearance around the transaxle oil cooler pipes and around the hoses to prevent damage or wear which may cause fluid loss.
  1. Install the TOC hoses to the vehicle.
  2. Install the TOC hoses to the radiator support retainer. See Figure .
  3. Connect the TOC inlet hose to the radiator. See OIL COOLER PIPES QUICK CONNECT FITTING  .
  4. Install the TOC inlet hose to the transaxle. See Figure .
  5. Install the TOC outlet hose to the transaxle. See Figure .
  6. Install the TOC hose retainer and the bolt. See Figure . Tighten the TOC hose retainer bolt to specification. See TORQUE SPECIFICATIONS  .
  7. Lower the vehicle.
  8. Connect the TOC outlet hose to the top side of the radiator. See OIL COOLER PIPES QUICK CONNECT FITTING  .
    CAUTION: DO NOT overfill the transaxle. The overfilling of the transaxle causes foaming, loss of fluid, shift complaints, and possible damage to the transaxle.
  9. Adjust the fluid level. See CHECKING FLUID LEVEL & CONDITION  under LUBRICATION.
scientia non olet · About LEMON Manuals