LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 225 (Automatic Transmission Servicing) >> Removal & Installation >> Accumulator & 2-1 Manual Servo >> Removal

Accumulator & 2-1 Manual Servo: Removal

WARNING: This page is about a different car, the 2003 Pontiac Montana, 2003 Oldsmobile Silhouette, and 2003 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle.
  2. Remove the oil pan and filter. See DRAINING & REFILLING  under LUBRICATION.
  3. Remove the accumulator bolts. See Fig 1 .
  4. Remove the manual 2-1 band servo cover bolts.
  5. Use a large flat-blade tool in order to gently pry the lube oil pipe retainer from the case. See Fig 2 .
  6. Remove the lube oil pipe from the front differential carrier internal gear lube hole.
  7. Remove the accumulator. See Fig 3 .
  8. Remove the manual 2-1 band servo cover.
  9. Remove the manual 2-1 band servo. See Fig 4 .
  10. Remove the manual 2-1 band servo cover gasket.
  11. To disassemble, inspect and service the accumulator and 2-1 manual servo, see appropriate OVERHAUL article.
Fig 1: Identifying Accumulator & 2-1 Manual Servo Cover Bolts
G98J01966Courtesy of GENERAL MOTORS CORP.
Fig 2: Removing & Installing Lube Oil Pipe
G00057602Courtesy of GENERAL MOTORS CORP.
Fig 3: Removing & Installing Accumulator & 2-1 Manual Band Servo
G00073383Courtesy of GENERAL MOTORS CORP.
Fig 4: Removing & Installing 2-1 Manual Band Servo & Seal
G00073382Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals