Filler Tube: Removal
WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.
- On 2.2L models, remove the bolt securing the dipstick to the exhaust manifold. See Fig 1.
- On all models, remove the transmission oil level indicator.
- Raise and support the vehicle.
- If the vehicle is equipped with a 2.2L engine, proceed to step 7.
- If the vehicle is equipped with a 4.3L engine, remove the exhaust manifold pipe.
- Remove the rear drive shaft. See appropriate DRIVE SHAFTS & UNIVERSAL JOINTS article in DRIVELINE/AXLES.
- Support the transmission and transfer case (if equipped) with a suitable jack.
- Remove the transmission support. See Fig 2.
- Lower the transmission to gain access to the bolt securing the filler tube to the transmission torque converter housing, and remove bolt.
- Remove the filler tube and seal from the vehicle. See Fig 3.