LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 219 (Servicing - A/T (VT25-E)) >> Removal & Installation >> Transaxle Oil Cooler >> Removal

Transaxle Oil Cooler: Removal

WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove front fascia. See FRONT FASCIA  .
  2. Separate transaxle oil cooler lines from radiator.
  3. Remove oil cooler line-to-radiator bracket bolt.
  4. Remove battery box inlet air duct. See Fig 1 .
  5. Remove condenser splash shield. See Fig 2 .
  6. Remove upper Condenser Radiator Fan Module (CRFM) bracket assemblies. See Fig 3 .
  7. Unclip condenser from radiator. See Fig 4 .
  8. Unclip transaxle oil cooler from radiator and remove transaxle oil cooler.
Fig 1: Removing & Installing Air Inlet
G00078067Courtesy of GENERAL MOTORS CORP.
Fig 2: Removing & Installing Condenser Splash Shield
G00078068Courtesy of GENERAL MOTORS CORP.
Fig 3: Removing & Installing Condenser Radiator Fan Module Bracket Assemblies
G00078069Courtesy of GENERAL MOTORS CORP.
Fig 4: Identifying Transaxle Oil Cooler Retaining Clips
G00078070Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals