LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 213 (Engine Controls - Self-Diagnostics - 3.0L) >> Diagnostic Tests >> DTC P0610: ECM Not Programmed For Correct Option Content >> Diagnostic Procedures

Diagnostic Procedures

WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Did you perform the Diagnostic System Check - Engine Controls? If yes, go to next step. If no, go to DIAGNOSTIC SYSTEM CHECK - ENGINE CONTROLS .
  2. Turn ignition on. Observe the ABS option content information with a scan tool. Does the ABS option content match the vehicle? If yes, go to step  4. If no, go to next step.
  3. Program the Body Control Module (BCM). Refer to appropriate BODY CONTROL MODULES article in ACCESSORIES & EQUIPMENT. After programming BCM, go to step  6.
  4. Program the ECM. See ENGINE CONTROL MODULE  under PROGRAMMING. Turn ignition off for 90 seconds. Start engine. Does the DTC fail this ignition? If yes, go to next step. If no, go to step  6.
  5. Replace ECM. Perform ECM relearn procedures. See ENGINE CONTROL MODULE  under PROGRAMMING. After replacing ECM, go to next step.
  6. Clear the DTCs with a scan tool. Turn ignition off for 90 seconds. Start engine. Does the DTC fail this ignition? If yes, go to step  2. If no, go to next step.
  7. Observe the Capture Info with a scan tool. Are there any DTCs that have not been diagnosed? If yes, diagnose affected DTC(s). See DIAGNOSTIC TROUBLE CODE DEFINITIONS . If no DTCs are displayed, system is okay.
scientia non olet · About LEMON Manuals