LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 21 (HVAC Systems - Manual) >> Symptom Tests >> Test B: Blower Motor Always On

Test B: Blower Motor Always On

WARNING: This page is about a different car, the 2002 Buick Regal and 2002 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
  1. If diagnostic system check was not performed, go to DIAGNOSTIC SYSTEM CHECK  under SELF-DIAGNOSTICS SYSTEM. If diagnostic system check was performed, go to next step.
  2. Turn ignition on. Place blower motor switch in OFF position. If blower motor is off, check wiring systems and connectors for loose, damaged or poor connections. If blower motor is on, go to next step.
  3. Ensure blower motor switch is in OFF position. Turn ignition off. Disconnect blower motor resistor harness connector. Turn ignition on. Using test light connected to ground, individually probe blower motor resistor harness connector terminals "A" (Tan wire), "B" (Yellow wire), "C" (Purple wire) and "D" (Light Blue wire). See Fig 1. If any wire causes test light to illuminate, go to next step. If test light does not illuminate, go to step  5.
  4. Check suspect blower motor control circuit for short to voltage. See WIRING DIAGRAMS . Repair suspect wire as necessary. After repair, go step  10. If wire is okay, go to step  7.
  5. Visually inspect blower motor supply circuit for short to voltage. See WIRING DIAGRAMS . Repair wire as necessary. After repair, go to step  10. If short to voltage is not found, go to next step.
  6. Check for poor connections or connector damage at blower motor resistor harness connector. Repair or replace as necessary. After repair, go to step  10. If connections are okay, go to step  8.
  7. Check for poor connections or connector damage at A/C-heater control panel harness connector. Repair or replace as necessary. After repair, go to step  10. If connections are okay, go to step  9.
  8. Replace blower motor resistor. See BLOWER MOTOR RESISTOR  under REMOVAL & INSTALLATION. After repair, go to step  10.
  9. Replace A/C-heater control module. See HVAC CONTROL MODULE  under REMOVAL & INSTALLATION. After repair, go to next step.
  10. Operate system to verify repair. If system operates normally, repair is complete. If system does not operate normally, return to step  2.
Fig 1: Identifying Blower Motor Resistor Harness Connector Terminals
G98I03050Courtesy of GENERAL MOTORS CORP.
Fig 2: Identifying A/C-Heater Control Panel Black 8-Pin Harness Connector C1 Terminals
G98E03048Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals