Removal Procedure
WARNING: This page is about a different car, the 2002 Buick Regal and 2002 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
- Grasp the switch on the left and right sides.
Important: The switch must be rotated, pulled down on the left side, to be removed.
- Use 2 small, flat-bladed tools to disengage the clips which are located at the front and rear of the switch. Hold the flat-bladed tools parallel to the roof and push straight in.
- Rotate the switch toward the left side to disengage it from the mounting bracket and pull down.
- Disconnect the electrical connector from the switch.
- Remove the switch from the vehicle.