LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 178 (Power Sun Roof) >> Repair Instructions >> Sunroof Glass Height and Opening Fit Adjustment >> Sunroof Glass Panel Height Adjustment

Sunroof Glass Panel Height Adjustment

WARNING: This page is about a different car, the 2002 Buick Regal and 2002 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
  1. Slide the sunroof sunshade to the open position.
  2. Position the sunroof glass panel to the fully closed position.
  3. Loosen the four sunroof glass panel adjusting screws 2 screws on each side. The screws must remain tight enough to have the sunroof glass panel retain its adjusted position.
    4. Fig 1: Identifying Sunroof Glass Panel Adjusting Screws
    G01755970Courtesy of GENERAL MOTORS CORP.
  4. Individually adjust the 4 corners of the glass panel.
  5. Adjust the front of the sunroof glass panel. Ensure that the sunroof glass front (3) is 0.787 mm (0.031 in) below the top surface of the roof panel. Also, the glass seal (1) is centered.
    6. Fig 2: Identifying Sunroof Glass Panel Height Adjustment Measuring Points
    G01755971Courtesy of GENERAL MOTORS CORP.
  6. Adjust the rear of the sunroof glass panel. Ensure that the rear of the sunroof glass (2) is 0.787 mm (0.031 in) above the top surface of the roof panel.
  7. Verify the adjustment of the sunroof glass panel seal.
    NOTE: Refer to FASTENER NOTICE .
  8. Tighten the sunroof glass panel screws. Tighten the screws to 4 N.m (35 in lbs).
    Fig 3: Identifying Sunroof Glass Panel Adjusting Screws
    G01755972Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals