LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 165 (Engine Mechanical - 4.0L (On-Vehicle)) >> Repair Instructions >> Engine Mount Replacement - Right >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the right engine mount (2) to the frame rail.
  2. Install the right engine mount attaching bolt (1) and nut (4) to the frame rail.
    Fig 1: Installing Right Engine Mount
    G01819215Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer toFASTENER NOTICE .
  3. Install the two nuts (3) securing the right engine mount to the rail.

    Tighten 

    Tighten the right engine mount to body rail nuts (3,4) to 70 N.m (52 ft lbs).

  4. Raise the engine into position.
  5. Install the nut securing the right engine mount to the right engine mount bracket.

    Tighten 

    Tighten the right engine mount nut to 80 N.m (59 ft lbs).

    6. Fig 2: Installing Engine Mount To Engine Mount Bracket Nut
    G01819216Courtesy of GENERAL MOTORS CORP.
  6. Remove the engine support jack.
  7. Install the right front wheel. Refer to TIRE AND WHEEL REMOVAL AND INSTALLATION .
  8. Lower the vehicle.
scientia non olet · About LEMON Manuals