LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 165 (Engine Mechanical - 4.0L (On-Vehicle)) >> Repair Instructions >> Crankshaft Balancer Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the crankshaft balancer on the nose of the crankshaft.
    Fig 1: Installing Crankshaft Balancer
    G01819277Courtesy of GENERAL MOTORS CORP.
  2. Press the crankshaft balancer in place using the J 41998-B 
    Fig 2: Pressing Crankshaft Balancer In Place
    G01819278Courtesy of GENERAL MOTORS CORP.
  3. Clean the crankshaft balancer bolt threads.
  4. Apply engine oil to the crankshaft balancer bolt threads.
    CAUTION: Refer toFASTENER NOTICE .
  5. Install the crankshaft balancer bolt.
    1. 5.1. First Pass

      Tighten 

      Tighten the crankshaft balancer bolt to 50 N.m (37 ft lbs).

    2. 5.2. Final Pass

      Tighten 

      Tighten the crankshaft balancer bolt an additional 120 degrees using the J 36660-A. 

    Fig 3: Installing Crankshaft Balancer Bolt
    G01819279Courtesy of GENERAL MOTORS CORP.
  6. Raise the engine assembly into position.
    CAUTION: Refer toFASTENER NOTICE .
  7. Install the nut securing the right engine mount to the right engine mount bracket.

    Tighten 

    Tighten the right engine mount nut to 80 N.m (59 ft lbs).

    8. Fig 4: Installing Right Engine Mount Securing Nut
    G01819280Courtesy of GENERAL MOTORS CORP.
  8. Remove the engine support jack.
  9. Remove the J 44214. 
  10. Install the torque converter cover. Refer to TRANSAXLE (4T80-E) .
  11. Install the oil pan to transaxle brace.

    Tighten 

    Tighten the oil pan to transaxle brace bolts to 50 N.m (37 ft lbs).

    12. Fig 5: Installing Engine To Transaxle Brace Bolts
    G01819281Courtesy of GENERAL MOTORS CORP.
  12. Install the right front fascia extension. Refer to FASCIA EXTENSION REPLACEMENT -- FRONT .
  13. Install the right front wheel. Refer to TIRE AND WHEEL REMOVAL AND INSTALLATION .
  14. Lower the vehicle
  15. Install the drive belt. Refer to Drive Belt Replacement .
scientia non olet · About LEMON Manuals