LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 160 (Engine Controls - Removal & Installation) >> Sensors >> Manifold Absolute Pressure Sensor >> Removal (3.4L)

Removal (3.4L)

WARNING: This page is about a different car, the 2003 Pontiac Grand Am and 2003 Oldsmobile Alero. However, it is still accessible from the selected car via links, so may be relevant.
  1. Manifold Absolute Pressure (MAP) sensor is located on top left side of engine next to ignition coils. See Figure . Turn ignition switch to OFF position.
  2. Remove the screws that attach the MAP sensor to the bracket. See Fig 1 .
  3. Disconnect the MAP sensor harness connector.
  4. Disconnect the MAP inlet vacuum hose.
  5. Remove the MAP sensor from the bracket.
Fig 1: Removing/Installing MAP Sensor (3.4L)
G00226889Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals