LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 159 (Engine Controls - Removal & Installation) >> Sensors & Switches >> Knock Sensor >> Installation

Knock Sensor: Installation

WARNING: This page is about a different car, the 2003 Pontiac Sunfire and 2003 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ensure the KS threaded surfaces are clean before installation.
  2. Install the knock sensor. Tighten the knock sensor retaining bolt to specification. See TORQUE SPECIFICATIONS .
  3. Connect the knock sensor harness connector.
  4. Install the starter.
  5. Connect the negative battery cable. Tighten to specification. See TORQUE SPECIFICATIONS .
scientia non olet · About LEMON Manuals