LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 159 (Engine Controls - Removal & Installation) >> Relays & Solenoids >> EVAP Canister Purge Valve >> Removal

EVAP Canister Purge Valve: Removal

WARNING: This page is about a different car, the 2003 Pontiac Sunfire and 2003 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the Evaporative (EVAP) emission canister purge valve harness connector.
  2. Disconnect the vacuum pipe from the EVAP canister purge valve.
  3. Disconnect the purge pipe from the EVAP canister purge valve.
  4. Remove the EVAP canister purge valve and bracket. See Fig 1.
  5. Remove the EVAP canister purge valve from the purge bracket.
  6. Check for carbon release in the EVAP canister purge valve ports.
Fig 1: Removing/Installing EVAP Canister Purge Valve
G00217352Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals