LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 155 (Engine Control System - Removal & Installation) >> Motors, Relays & Solenoids >> EVAP Pressure Switching Solenoid >> Removal

EVAP Pressure Switching Solenoid: Removal

WARNING: This page is about a different car, the 2003 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove EVAP canister (3). See EVAP CANISTER  .
  2. Disconnect EVAP pressure switching solenoid harness connector.
  3. Disconnect 2 vapor hoses. See Fig 1 .
  4. Remove bolt (2).
  5. Remove EVAP pressure switching solenoid (1) from EVAP canister.
  6. Inspect EVAP pressure switching solenoid and EVAP control system for carbon particle contamination before replacing the EVAP pressure switching solenoid.
Fig 1: Removing/Installing EVAP Pressure Switching Solenoid
G00180651Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals