LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 152 (Removal & Installation - A/T (VT25-E)) >> Removal & Installation >> Powertrain Mount Balance (Total Mount)

Powertrain Mount Balance (Total Mount)

WARNING: This page is about a different car, the 2003 Saturn Vue and 2002 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle.
  2. Loosen the front mount through bolt. See Figure . DO NOT remove.
  3. Loosen the rear mount through bolt. See Figure . DO NOT remove.
  4. Position 2 floor jacks with wood blocks under the engine and transaxle to support the powertrain assembly.
  5. From the engine compartment, loosen, DO NOT remove the LH mount bolts. See Fig 2 .
  6. Loosen, DO NOT remove the RH mount bolts. See Fig 1 .
  7. Reposition the floor jacks to allow a 1/8" gap between the mount and mount bracket.
  8. Tighten the LH mount starting with the center bolt. See Fig 2 . Tighten bolts to specification. See TORQUE SPECIFICATIONS  .
  9. Tighten the RH mount starting with the center bolt. See Fig 1 . Tighten bolts to specification. See TORQUE SPECIFICATIONS  .
  10. Remove the floor jacks.
  11. Shake the powertrain vigorously from front to rear and allow the powertrain to settle.
  12. Tighten the rear mount through bolt. See Figure . Tighten bolts to specification. See TORQUE SPECIFICATIONS  .
  13. Tighten the front mount through bolt. See Figure . Tighten bolts to specification. See TORQUE SPECIFICATIONS  .
  14. Lower the vehicle.
Fig 1: Removing Right Engine Mount Bracket Bolts
G00210860Courtesy of GENERAL MOTORS CORP.
Fig 2: Removing Left Transaxle Mount Bolts
G00210861Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals