LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 14 (Disc Brakes) >> Removal & Installation >> Master Cylinder >> Removal

Master Cylinder: Removal

WARNING: This page is about a different car, the 2002 Pontiac Grand Prix and 2002 Oldsmobile Intrigue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the electrical connector from the brake fluid level sensor.
  2. Disconnect the brake pipes from the master cylinder.
    NOTE: Install a rubber cap or plug to the exposed brake pipe fitting ends in order to prevent brake fluid loss and contamination.
  3. Plug the open brake pipe ends.
  4. Remove master cylinder mounting nuts.
  5. Remove the master cylinder from the vehicle.
  6. Drain the master cylinder reservoir of all brake fluid.
scientia non olet · About LEMON Manuals