LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 138 (Automatic Transaxle Diagnosis - 4T65-E) >> Diagnostic Tests >> DTC P1826: Internal Mode Switch Circuit C - High >> Diagnostic Procedure

Diagnostic Procedure

WARNING: This page is about a different car, the 2003 Buick Regal and 2003 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
  1. Did you perform the diagnostic system check? If so, go to next step. If not, see DIAGNOSTIC SYSTEM CHECK  under SELF-DIAGNOSTIC SYSTEM.
  2. Install a scan tool. Turn ON the ignition with the engine OFF. Record the DTC Freeze Frame and Failure Records. Clear the DTC. Select IMS on the scan tool. Place the gearshift lever in D4. Does the scan tool IMS parameter indicate Drive 4? If so, see INTERMITTENT CONDITIONS within appropriate ENGINE PERFORMANCE article. If not, go to next step.
    NOTE: Before clearing the DTC, use the scan tool in order to record the Failure Records. Using the Clear Info function erases the Failure Records from the PCM.
  3. Turn OFF the ignition. Disconnect the AT inline 20-pin connector. Additional DTCs may set. Install the 20 Pin Jumper Harness (J 44152) on the engine side of the AT inline 20-pin connector. Using the GM Terminal Test Kit J 35616-A, connect a fused jumper wire from terminal "H" of the 20 pin jumper harness to a good ground. Turn ON the ignition, with the engine OFF. Select IMS A/B/C/P on the scan tool. Does IMS Signal "C" indicate LOW? If so, go to step  5 . If not, go to next step.
  4. Test the signal "C" circuit (CKT 773) of the IMS for an open between the PCM connector C1 and the AT inline 20-pin connector. Did you find and correct a condition? If so, go to step  9 . If not, go to step  8 .
  5. Test the signal "C" circuit (CKT 773) of the IMS for an open between the AT inline 20-pin connector and the IMS. Did you find the condition? If so, go to next step. If not, go to step  7 .
  6. Replace the automatic transmission wiring harness assembly. See TRANSAXLE INTERNAL WIRING HARNESS  under REMOVAL & INSTALLATION. When replacement is complete, go to step  9 .
  7. Replace the lever assembly-manual shaft detent with internal mode switch. See PARKING SYSTEM COMPONENTS  under REMOVAL & INSTALLATION. When replacement is complete, go to step  9 .
  8. Replace the PCM. See POWERTRAIN CONTROL MODULE  under REMOVAL & INSTALLATION. When replacement is complete, go to next step.
  9. Perform the following procedure in order to verify the repair:
    • Select DTC.
    • Select Clear Info.
    • Start and idle the engine in Park for 10 seconds.
    • Observe IMS A/B/C/P on the scan tool.
    • Move the gearshift lever to D1, D2, D3 and D4 positions. Ensure that IMS Signal "C" indicates LOW for each range.
    • Operate the vehicle within the "Conditions for Running the DTC" as specified in the supporting text.
    • Select Specific DTC.
    • Enter DTC P1826.

    Has the test run and passed? If so, go to next step. If not, go to step  2 .

  10. With a scan tool, observe the stored information, capture info and DTC info. Does the scan tool display any DTCs that you have not diagnosed? If so, go to appropriate ENGINE PERFORMANCE article. If not, the system is OK.
scientia non olet · About LEMON Manuals