LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 131 (Engine Controls - On-Vehicle Adjustments) >> Idle Speed & Mixture >> Automatic Throttle Valve (TV) Cable >> 2.0L

Automatic Throttle Valve (TV) Cable: 2.0L

WARNING: This page is about a different car, the 2003 Chevrolet Tracker. However, it is still accessible from the selected car via links, so may be relevant.
  1. Inspect the accelerator cable for proper adjustment. See ACCELERATOR CABLE ADJUSTMENT . Measure the distance between the tip end of the TV cable adjustment mark and the end of the boot. The distance must be 0.031-0.059" (0.8-1.5 mm). See Fig 1.
  2. If the distance is not 0.031-0.059" (0.8-1.5 mm), loosen the Throttle Control (TV) cable locknut (3). Adjust the cable using the locknuts until the measurement is achieved. Tighten the TV cable locknut (3). Measure the distance between the tip end of the TV cable adjustment mark and the end of the boot. Ensure that the distance did not change during the tightening of the locknut.
Fig 1: Checking TV Cable For Proper Adjustment (2.0L)
G00191817Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals