LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 10 (Analog Instrument Panels) >> System Tests >> Test H: Driver Information Center (DIC) Compass Inaccurate Or Cal Is Displayed

Test H: Driver Information Center (DIC) Compass Inaccurate Or Cal Is Displayed

WARNING: This page is about a different car, the 2002 Chevrolet Monte Carlo, 2002 Chevrolet Impala, 2001 Chevrolet Monte Carlo, and 2001 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
  1. Perform driver information center system diagnostic system check. See DRIVER INFORMATION CENTER SYSTEM DIAGNOSTIC SYSTEM CHECK  under SELF-DIAGNOSTIC SYSTEM. If driver information center system diagnostic system check has been performed, go to next step.
  2. Observe DIC. If compass is inaccurate, or CAL or C is displayed, go to next step. If compass is not inaccurate, or CAL or C is not displayed, check for intermittent problem. See DIAGNOSING INTERMITTENTS  . Repair or replace as necessary. After repair, go to step  8 .
  3. Turn ignition switch to RUN position. Observe DIC. If compass display is not blank, go to next step. If compass display is blank, go to step  7 .
  4. If compass displays CAL, go to next step. If compass does not display CAL, go to step  6 .
  5. Perform compass calibration procedure. See COMPASS CALIBRATION  under PROGRAMMING. If compass operation is okay, go to step  8 . If compass operation is not okay, go to next step.
  6. Perform compass magnetic variation adjustment procedure. See COMPASS MAGNETIC VARIATION ADJUSTMENT  under PROGRAMMING. If compass operation is okay, go to step  8 . If compass operation is not okay, go to next step.
  7. Replace DIC and calibrate compass. See DRIVER INFORMATION CENTER (DIC)  under REMOVAL & INSTALLATION. Go to next step.
  8. Operate system to verify repair. If system operates normally, repair is complete. If system does not operate normally, return to step  2 .